Bernette b48 FUNLOCK - How to Change Threads; Tie on method

34
2
2
1
8
4
5
7
6
3
2
10
1
9
10
3
3
6
7
8
10
5
4
9
10
3
3
6
7
8
10
5
4
9
10
3
3
6
7
8
10
5
4
9
10
– Continue to thread points (4)–(10).
Before threading eye of needle, slip thread behind
thread guide (9) located on the bottom of the needle
holder for Coverstitch.
PLEASE NOTE:
Slip thread into the front slot on the thread guide
(5) and lower slot of take-up lever cover (6).
Then slip thread into the left slot on the thread
guide (7), and into the left slot on the thread
guide (8).
– Thread the pre-tension guide by pulling the
thread towards the left until it slips under guide
(2). Then pull thread along the right side of pre-
tension as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs (3).
– The position of the thread must be behind the
thread guide.
– Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
– Thread the eye of the left needle (10).
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.