www.anglemaster.com
Finding 0° on Top Face – Scratch lightly with grinding stone Set 0°
On a BRAND NEW BLADE: Scratch across the face, instead of zero °, press reset button to set left hand “Where
you are” display to zero; hold reset button and press + or – buttons to increment the “where-you-are” display
to the correct angle for that blade: -7° Small; -9° Medium; -12° Large; the angle for that blade as ground by the
manufacturer – there is no wear yet. Add a maximum of 1° to this setting before truing the face of the blade.
Scratch: too back
Scratch: too forward
Too Back
Too Forward Correct
Press
the
RESET
button to set the left
“Where-you-are”
display to the current
angle of Zero.
ANGLEMASTER 3000
Rotate to
Top Face
Mount Bedknife against Tabs
Turn on Magnet and
secure bedknife to
Brackets.
Release and rotate
tabs away.
To Next Page
Loading...
