Errors and faults
122
13 Errors and faults
13.1 Error messages
Message on the display Cause Solution
Stitch number unknown. > Check the entry and enter the new number.
The stitch pattern cannot be
selected in the Combi-mode.
> Combine other stitches.
The feed dog is not lowered. > To lower the Feed Dog, push the button «Feed Dog Up/
Down»
.
The selected needle and stitch
plate cannot be used in
combination.
> Replace the needle.
> Replace the stitch plate.
The needle is not at its top end. > Adjust the needle position via the handwheel.
The upper thread is used up. > Rethread.
The upper thread has broken. > Rethread.
To Next Page
Loading...
