Bernina 740 - Threading Procedures

Sewing preparation
37
> Select the needle thickness (2) of the fitted needle.
1
2
Adjusting the needle position up/down
> To lower the needle, push the button «Needle Up/Down».
> To raise the needle, push the button «Needle Up/Down» again.
Adjusting the needle position left/right
There is a total of 11 needle positions. The needle position is indicated by the needle position number in the
display.
> To position the needle position to the left, push the button «Needle left»(1).
> To position the needle position to the right, push the button«Needle right»(2).
1 2
Needle stop up/down (permanent)
> To set the needle stop position permanently, tap «Needle Stop Up/Down».
– The machine stops with needle position down as soon as the foot control is released or the button
«Start/Stop» has been pushed.