Bernina 740 - Threading the Bobbin Thread

Sewing preparation
43
> Guide the thread to the left into the rear thread guide (2).
> Guide the thread around the bobbin winder pretension clockwise (3).
> Wind the thread clockwise 2–3 times around the empty bobbin(4).
2
3
4
> Pull the excess thread over the thread cutter at the engaging lever(5) and cut.
5
> Push the engaging lever(6) towards the bobbin.
6
– The machine winds and the display to wind the bobbin appears.
> Set winding speed.
> To stop the winding process, the engaging lever must be pushed to the right.
> Push the engaging lever towards the bobbin again to continue the winding process.
– As soon as the bobbin is full, the machine stops the winding process automatically.
> Remove the bobbin and cut the thread using the thread cutter at the engaging lever.
Threading the bobbin thread
Prerequisite:
• The needle is raised.
• The machine is switched off and the bobbin cover is opened.