Bernina 740 - Calibrating the Buttonhole Foot No. 3 A; Reviewing the Total Number of Stitches

Setup Program
53
> Tap «Factory Setting».
> To delete all data from the Personal Memory, tap «Delete data from own storage medium» and confirm.
Calibrating the Buttonhole foot No. 3A
The Buttonhole foot with slide#3A is calibrated to the machine and they should only be used both
together.
Prerequisite:
• The Buttonhole foot with slide#3A is fitted.
• The needle is not threaded.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Maintenance/Updates».
> Tap «Calibrating the Buttonhole foot#3A».
> To start the calibration, push the «Start/Stop» button.
Reviewing the total number of stitches
The total number of stitches by the machine and the number of stitches since the last maintenance carried
out by a specialist BERNINA dealer are displayed.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Information».
> Tap «Machine Data».