· Select the Needle to Move to
· Move One Needle Down
Needle Case Adjustments
The needle case calibration table can be adjusted and tested using the following buttons on the lower portion
of the screen.
· Shift Needle Case Left - also adjusts the table on the machine's board
· Shift Needle Case Right - also adjusts the table on the machine's board
Test any adjustments easily by cycling from one needle to the next.
· Cycle Needles
1. This moves the needle to head up
2. moves one needle up
3. then moves the needle to bottom center.
Status Log
The status log shows the latest captured action of the machine.
Tapping this will open the status log and display a history of actions along with timestamps.
To Next Page
Loading...