6. When nished, line up the thread under the pinch roller and press the pinch roller back down.
7. If desired, the thread can then be held by the retaining spring in front of the lower thread guide
or held in place using the grabber. With your hands out of the way, tap the Grabber In / Grabber
In button to close the grabber and move the thread into the holder behind the needles.
8. Trim the end to about an inch in length.
9. Tap the Grabber Out button to open the grabber again.
Upper Thread Path
If the thread comes out of the system, you may need to thread the machine without a
starter thread.
To Next Page
Loading...