4. Pull the thread from the hole and place it under the pinch roller. Bring the thread down through the
upper thread guide.
5. Pull the thread down to the middle thread guide. Of the three holes, push the thread from the top
through the back right hole. Make sure the thread is on the right side of the take-up lever.
6. Bring the thread around the thread sensor from back to front and up through the front hole of the
middle thread guide.
7. Pull the thread up and through the eye of the take-up lever from right to left.
8. Route the thread straight down through the back left hole in the middle thread guide.
To Next Page
Loading...