Bernina E 16 PRO - Page 36

36
Inserting the Bobbin Case
1. Insert the bobbin and case in the machine with the pigtail facing up. Push on the bobbin case until it
snaps into place.
2. Test the bobbin orientation by pulling on the thread. The bobbin should rotate counter-clockwise.
3. Trim the thread to 2 - 3 inches.
Warning!!

Never attempt to remove or insert the bobbin while the machine is in operation.
Note:

If the thread is cut too short, it will not pick up on the stitch. If the thread is left too long, it may
wrap into the machine.