· Satin stitches - Not enough bobbin is showing on the back of the design.
· Fill stitches - You are encountering thread breaks, and the stitches in the design are looping.
· False Bobbin Breaks - When the software falsely detects bobbin breaks that are not truly broken
thread, it could be that your material thickness is too high.
Advanced Acti-Feed Calibration
Acti-Feed behavior is based on the play of the thread through the system and against the sensor. One of the
key factors is the bobbin tension. If your desired tension is dierent than that called out in theBobbin
Threading & Tensioningsection, theAdvanced Acti-Feed Calibrationsection shows how Acti-feed can be
adjusted to suit your needs or the needs of your embroidery application.
To Next Page
Loading...