· Force Design Return to Origin
o When disabled, the hoop position may remain at the last stitch of the design. Many
designs already end with a return to origin command.
o When enabled, the hoop position will return to design origin whether or not the design
le ends with that command.
· Tail Length
o This adjusts the length of the upper thread left behind to start the next stitch after a trim.
· Trim Type
o This slightly alters the trim behavior of the machine.
§ Normal - used for most threads
§ Metallic - altered to improve trimming on some of the stretchier metallic threads
Color Sequence Settings
· Closest Color Match on Load
o When disabled, the color sequence is not automatically color-matched.
o When enabled, the color sequence is automatically matched as closely as possible to the
thread colors currently assigned to the thread tree.
Because color information from software providers, software versions, and thread
manufacturer color card versions vary, it is recommended that the color sequence be
reviewed before sewing.
To Next Page
Loading...