Care and maintenance
60
> Tap «Setup Pogram».
> Tap «Machine settings».
> Tap «Maintenance/updates».
> Tap «Updating firmware».
> To back up personal data and settings, tap «Save Data».
– Wait until the data has been backed up onto the USB stick.
NOTICE
Incomplete update due to removing the BERNINA USB stick too early
If the software has not been updated or has not been fully updated, the machine cannot be used.
> Remove the BERNINA USB stick only once the update has been successfully completed.
> To start the firmware update, tap «Starting firmware update».
– Wait until the firmware update has finished.
Starting the Service Programm
The Service Program allows the service technician to fix errors and to readjust individual functions.
Along with the diagnostic instructions in the service manual, the service program is accessible and usable for
diagnosis by the user and remote diagnosis. The BERNINA specialist dealer can check the functions and give
support for troubleshooting.
NOTICE
Wrong settings in Service Program
Impairment of the machine function.
> Carry out settings in the service program only under the guidance of the specialist dealer or have them
carried out by the specialist dealer.
> Password protected settings can only be carried out by the specialist dealer.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Machine settings».
> Touch the icon «Maintenance/Update».
To Next Page
Loading...
Need help?
General
