BestCode NExT 82 - Page 190

BestCode Next Series 8 Technical Manual October 2022 Page 176 of 290
Prompt Code
Prompt Name
Prompt Description
10-0002
Ink Empty
Ink fluid level empty.
Solution 1:
Add Ink to the system: Instructions.
Solution 2:
Replace Ink level switch.
Prompt Code
Prompt Name
Prompt Description
10-0003
Ink Low
Ink fluid level is low.
Solution 1:
Add Ink to the system: Instructions.
Solution 2:
Replace Ink level switch.
Prompt Code
Prompt Name
Prompt Description
10-0004
Ink Stir
Ink Stir Started
Solution 1:
No action required. 88SOP, 88SHSOP Machines only. May be set active in technician on all other
models.
Prompt Code
Prompt Name
Prompt Description
10-0005
Ink Full
Ink tank full, do not add ink.
Solution 1:
Self-descriptive.
Solution 2:
If ink level in the tank is visibly low, check Ink Level switch or replace.
Prompt Code
Prompt Name
Prompt Description
10-0006
Ink Life
"Ink Life is at maximum."
Occurs after trying to Scan an Ink SmartFill label after very little ink usage since last scan. Helps
prevent accidental SmartLabel destruction.
Solution 1:
Start jet and try to scan tag again. If error repeats, do not add fluids until prompted.
Prompt Code
Prompt Name
Prompt Description
10-0007
Ink Life
"Ink level has risen to Full."
Ink level switch moved to full state. System OK.
Prompt Code
Prompt Name
Prompt Description
10-8001
Ink Fault
SmartFill label not valid for this machine.
Solution 1:
Label type cannot be used in the BestCode machine. Contact BestCode.
Prompt Code
Prompt Name
Prompt Description
10-8002
Ink Fault
SmartFill label not valid for this machine type.
Solution 1:
The ink type cannot be used in this model of machine. Check the Commission screen for acceptable ink
types.
Prompt Code
Prompt Name
Prompt Description
10-8003
Ink Fault
SmartFill label not valid for this machine setting.
Solution 1:
The wrong fluid is being installed. Do not add this bottle. Check the Info screen for the commission ink
type and add the correct fluid.