BestCode NExT 82 - Viscosity Check During Run

BestCode Next Series 8 Technical Manual October 2022 Page 177 of 290
Prompt Code
Prompt Name
Prompt Description
10-8004
Ink Fault
Ink fluid level could not be determined.
Solution 1:
Ink float switch is not plugged in. Check connection on J32.
Solution 2:
Ink float switch is not operating correctly. Replace the Ink Float Switch.
Prompt Code
Prompt Name
Prompt Description
10-8005
Ink High
Ink fluid level too high to operate.
Solution 1:
Ink float switch is not operating correctly. Inspect the fluid level in the ink tank. If fluid level is OK,
replace the Ink float switch.
Solution 2:
Ink tank is over-filled. Drain the ink from the tank and install fresh ink. Ensure that the CPU Hardware
Generation is set correct to the fluidic system and check for faulty valves.
Prompt Code
Prompt Name
Prompt Description
10-8006
Ink Fault
SmartFill ink label required.
Solution 1:
Scan SmartFill ink label. Do not add Ink Bottle. Occurs when fluid is added but SmartFill label is not
read. Review how to add Ink here.
Prompt Code
Prompt Name
Prompt Description
10-8007
Ink Fault
SmartFill ink label required.
Solution 1:
Check Ink Level and inspect Ink Level switch function.
Solution 2:
See 10-8006.
Prompt Code
Prompt Name
Prompt Description
10-8008
Not Used
-
Solution 1:
Load New Firmware.
Prompt Code
Prompt Name
Prompt Description
10-8008
Not Used
-
Solution 1:
Load New Firmware.
Prompt Code
Prompt Name
Prompt Description
10-800A
Ink Empty
"SmartFill ink label required."
Solution 1:
Check Ink Level and inspect Ink Level switch function.
Solution 2:
Add Ink here.
Prompt Code
Prompt Name
Prompt Description
10-800B
Ink Empty
"SmartFill ink label required."
Solution 1:
Check Ink Level and inspect Ink Level switch function.
Solution 2:
Scan SmartFill Label only. Train operators on properly adding fluids.
Prompt Code
Prompt Name
Prompt Description
10-800C
Ink Empty
"SmartFill ink label required."
Solution 1:
Same as 10-800A, except only occurs at Jet Start.