EasyManuals Logo

Beta RR 50 cc ENDURO User Manual

Beta RR 50 cc ENDURO
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
2
OPERATION
33
GB
OIL MIXER REFUELLING
To refuel open the tank cap (page 18).
Fuel tank capacity is shown on page 11.
After refuelling, screw the cap back and tighten securely.
Use the oil indicated on page 16 in the “Recommended lubricants and liquids”
table.
STARTING THE ENGINE
Move the fuel tank valve in ON or RES position (page 18).
Check that the gears are in neutral (page 20).
Pull the clutch lever (page 20).
Close the side stand (page 21).
WITH KICK-STARTER (page 21):
Depress the kick-starter with a sharp movement of the foot.
ATTENTION
Once the pedal has been depressed, release it immediately. This avoids
jolts to the entire ignition group and to the foot.
COLD STARTING:
Operate the starter (page 19), start the vehicle, wait a few seconds, then move
the starter back to its starting position.
ENGINE SHUT-DOWN
To shut-down the engine, proceed in one of the two following ways:
- turn the key to (see page 22).
- press the button on the switch unit (see page 20).
NOTE:
With the engine off, make sure the fuel cock is set to OFF (page 18).

Table of Contents

Other manuals for Beta RR 50 cc ENDURO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta RR 50 cc ENDURO and is the answer not in the manual?

Beta RR 50 cc ENDURO Specifications

General IconGeneral
BrandBeta
ModelRR 50 cc ENDURO
CategoryMotorcycle
LanguageEnglish

Related product manuals