4
CHECKS AND MAINTENANCE
43
GB
1
2
REAR BRAKE
CHECK THE LEVEL OF THE REAR
BRAKE FLUID
Check oil level by means of oil container
1.
Oil level must never be below the minimum
level mark on container.
To restore the oil level, top up by means
of oil filler cap 2.
WARNING:
If the pedal feels soft, there may be an
air bubble in the circuit, then contact
authorised Betamotor authorised service
immediately.
NOTE:
Use the liquid indicated on page 16 in
the “Recommended lubricants and liquids”
table.
2 mm
FRONT BRAKE LINING CONTROL
To check the wear of the front brake pads,
visually inspect the caliper from below. The
lining on the visible ends of the two brake
pads should be at least 2 mm thick.
If this layer is thinner than 2 mm, replace
the pads immediately.
Note:
Perform the check according to the times
shown in the table on
page 53.
To replace, contact authorised Betamotor
customer service.
To Next Page
Loading...
Need help?
General
