4
CHECKS AND MAINTENANCE
41
GB
LIQUID COOLANT
The level check must be performed with
the engine cold, as follows:
- Hold the motorcycle vertical to the ground
- remove the cap A and check that the
level of the liquid covers all the radiator
elements. If it does not, add liquid until
all elements are covered.
At the end of operation refit the filler cap.
NOTE:
The FACTORY version is equipped with a
dual radiator.
NOTE:
The circuit capacity of the Factory version
is 850cc, while for all other versions, it
is 500 cc. Use the fluids specified in the
table on page 16.
WARNING:
Never unscrew the filler cap of the
radiator when the engine is hot.
Danger of burning
!
A
B
WARNING:
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
Avoid any direct contact of the coolant with skin, eyes or clothing. If this hap-
pens:
- with the eyes, rinse immediately with plenty of water and seek medical advice;
- with skin, Immediately clean contaminated areas with soap and water Change
clothing that is contaminated with coolant.
If coolant is swallowed, contact a doctor immediately.
To Next Page
Loading...
Need help?
General
