Binder APT.line C 150 - Page 79

Binder APT.line C 150

79 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

Table of Contents

Default Chapter4
- Table of Contents4
1 Safety7
- Legal Considerations7
- Structure of the Safety Instructions7
- Localization / Position of Safety Labels at the Unit9
- Type Plate10
- General Safety Instructions on Installing and Operating the CO Incubator12
- Intended Use13
2 Unit Description14
- The CO Measuring Principle14
- Unit Overview15
- Connection Panel at the Rear of the Unit16
- Triangle Instrument Panel C 15016
- Unit Doors17
3 Completeness of Delivery, Transportation, Storage, and Installation17
- Unpacking, and Checking Equipment and Completeness of Delivery17
- Guidelines for Safe Lifting and Transportation18
- Storage19
- Location of Installation and Ambient Conditions19
4 Installation and Connections20
- Shelves20
- CO 2 Sensor21
  - Connecting the CO 2 Sensor21
- Water Pan22
- Gas Connection22
- Electrical Connection25
5 Start up26
6 Function Overview of the Rp1 Controller26
- Preset Factory Parameters27
- Performance after Turning on the Unit27
7 Controller Rp1 Operating Modes28
- Selecting and Setting the Operating Functions29
- Operating Mode HAND29
- Operating Mode USER: Advanced Settings31
- Operating Mode LOCK: Locking/Unlocking of the Operating Functions' Settings by Operating Mode HAND35
- Performance During and after Power Failures and Shut down36
8 Controller Rp1 Settings36
- Altitude of the Installation Site above Sea Level36
- Entering the Set Points of Temperature and CO38
9 Temperature Safety Devices39
- Over Temperature Protective Device (Class 1)39
- Safety Controller (Temperature Safety Device Class 3.1)39
  - Setting the Safety Controller Set Point Type39
  - Setting the Safety Controller Set Point41
10 Alarm Functions43
- Alarm Functions Overview43
- Resetting the Alarm Messages43
- Zero-Voltage Relay Alarm Output44
- Safety Controller Temperature Alarm45
- Temperature Tolerance Range Alarm (High and Low Temperature)45
- Door Open46
- CO Tolerance Range Alarm (CO Over/Under Concentration)47
- CO Pressure too Low47
- Temperature Sensor Failure48
- Failure of CO Sensor49
11 Error Messages49
12 Reference Measurements50
- CO Reference Measuring50
  - Concentration Indirectly Via the Ph of the Cell Medium50
  - Measuring CO Directly Via Chemical Indicator Tubes51
- Temperature Reference Measurement52
  - Measuring CO Directly with an Electronic Infrared Measuring Device52
13 Options52
- Silicone Access Ports 30 MM / 1.18 In, Closable with 2 Silicone Plugs (8012-0558 Rear, 8012-0559 Left, 8012-0560 Right) (Option)52
- Base on Castors (Option)53
- Stacking Adapter for Direct Thermal Decoupled Stacking (Option)53
- Analog Outputs for Temperature and CO (Option)53
14 Avoiding Microbial Contamination54
- Cells and Media54
- Laboratory Conditions / Equipment Around the Incubator54
- Working and Behavior in the Lab54
- Chamber Design and Equipment of the CO Incubator C 15055
- Handling the CO Incubator C 15056
15 Cleaning, Decontamination / Disinfection, and Sterilization57
- Cleaning57
- Decontamination / Chemical Disinfection58
- Disinfection of the CO59
- Hot-Air Sterilization at 180 °C / 356 °F59
  - Sensor59
- Aborting the Hot-Air Sterilization62
16 Maintenance, and Service65
- Maintenance Intervals, Service65
- Checking the Air Jacket Heating Fan65
- Gas Inlet Fine Filter65
- Sending the Unit Back to BINDER Gmbh66
17 Disposal66
- Disposal of the Transport Packing66
  - Outer Unit Packing66
  - Packing Inside the Unit, Equipment67
- Decommissioning67
- Disposal of the Unit in the Federal Republic of Germany67
- Disposal of the Unit in the Member States of the EC Except for the Federal Republic of Germany68
- Disposal of the Unit in Non-Member States of the EC69
18 Technical Description70
- Factory Calibration and Adjustment70
- Over Current Protection70
- Definition of Usable Volume70
- C 150 Technical Data71
- Important Conversion Data for Non-SI Units72
- Conversion Table for Gas Inlet Pressures, Bar - Psi72
- Equipment and Options C 15073
- Accessories and Spare Parts74
- Dimensions C 15075
19 Contamination Clearance Certificate76

Related product manuals

Binder APT.line C 150-UL

Binder APT.line BD 23

Binder APT.line BD 53

Binder APT.line FD 23

Binder APT.line KT 53

Binder APT.line BD 240

Binder APT.line BD 720

Binder APT.line ED 53-UL

Binder APT.line FD 53-UL

Preview: Binder APT.line BD Series

Binder APT.line BD Series

Preview: Binder APT.line KB Series

Binder APT.line KB Series

Binder KB 115 (E4)