Binder CB-S 170 - 27. Certificates and Declarations of Conformity; 27.1 EU Declaration of Conformity

119 pages

Save Page as PDF

To Next Page

To Previous Page

CB-S / CB-S-UL (E7) 06/2020 page 111/119

27. Certificates and declarations of conformity

27.1 EU Declaration of Conformity

Main Page

Default Chapter2
- Table of Contents2
1 Safety6
- Personnel Qualification6
- Operating Manual6
- Legal Considerations6
- Structure of the Safety Instructions7
- Localization / Position of Safety Labels at the Chamber9
- Type Plate10
- General Safety Instructions on Installing and Operating the Chamber11
- Precautions When Working with CO Gas13
- Precautions When Handling Gas Cylinders13
- Intended Use14
- Foreseeable Misuse15
- Residual Risks16
- Operating Instructions17
- Measures to Prevent Accidents18
2 Chamber Description19
- Chamber Overview20
- Inner Chamber21
- Connection Panel on the Rear of the Chamber22
- Chamber Doors23
- Instrument Panel23
3 Completeness of Delivery, Transportation, Storage, and Installation24
- Unpacking, and Checking Equipment and Completeness of Delivery24
- Guidelines for Safe Lifting and Transportation25
- Storage25
- Location of Installation and Ambient Conditions25
4 Installation and Connections28
- Shelves28
- CO 2 Sensor28
- Water Pan29
- Gas Connection30
  - Connecting the CO Gas Cylinder31
  - Gas Cylinder Connection Kit (Option)33
- Electrical Connection34
5 Functional Overview of the Rd4 Chamber Controller35
- Menu Structure of the Controller and Access Levels36
- Performance During and after Power Failures and Shut down37
6 Start up37
- Turning on the Chamber37
- Preset Factory Parameters38
- Performance after Turning on the Chamber38
- Altitude of the Installation Site above Sea Level39
7 Temperature and Co Set-Point Entry40
- Temperature Set-Point Entry40
- CO Set-Point Entry40
8 Placing Samples in the Incubator41
9 Setting Special Controller Functions42
- Idle Mode42
- Deactivated CO 2 Control43
10 Password43
- Password Request43
- Assign and Modify a Password44
  - Assign and Modify the User Password44
  - Assign and Modify the Admin Password44
11 Temperature Safety Devices45
- Over Temperature Protective Device (Class 1)45
- Overtemperature Safety Controller Class 3.145
12 General Controller Settings48
- Selecting the Controller's Menu Language48
- Selecting the Temperature Unit48
- Setting the Current Date49
- Setting the Current Time50
- Function "Language Selection at Restart50
- Setting the Chamber Address51
- Display Brightness51
13 Tolerance Range Settings52
- Setting the Delay Time for Tolerance Range Alarm52
- Setting the Temperature Tolerance Range52
- Setting the CO Tolerance Range53
- Setting the Delay Time for Door Open Alarm53
14 Chamber Settings (for Experienced Users Only)54
- Setting the Humidity Control54
- Setting the Door Heating Offset54
- Adjusting the Heating Power - for BINDER Service Only55
15 Notification and Alarm Functions55
- Alarm Messages55
- Information Messages57
- Activating / Deactivating the Audible Alarm (Alarm Buzzer)58
- Measures in Case of Alarm58
- Zero-Voltage Relay Alarm Output64
16 Ethernet Network Settings65
- Showing the Network Settings65
- Changing the Configuration of the Network Settings67
17 Data Recorder70
- Recorded Data70
- Storage Capacity71
- Setting the Storage Rate for the "DL1" Recorder Data71
- Deleting the Data Recorder71
18 Usb Menu: Data Transfer Via Usb Interface72
- Connecting the USB Stick72
- Import Function73
- Export Functions73
- Ongoing Data Transfer74
- Error During Data Transmission74
- Removing the USB Stick74
19 Reference Measurements75
- CO Reference Measuring75
  - Measuring the CO Concentration Indirectly Via the Ph of the Cell Medium75
  - Measuring CO Directly Via Chemical Indicator Tubes76
- Temperature Reference Measurement77
  - Measuring CO 2 Directly with an Electronic Infrared Measuring Device77
20 Options77
- Silicone Access Ports 30 MM / 1.18 In, Closable with 2 Silicone Plugs (8012-0558 Rear, 8012-0559 Left, 8012-0560 Right) (Option)77
- Base on Castors (Option)78
- Flat Stacking Frame (Option)78
- APT-COM™ 4 Multi Management Software (Option)78
- Data Logger Kit (Option)78
- Analog Outputs for Temperature and CO (Option)79
21 Avoiding Microbial Contamination79
- Cells and Media79
- Laboratory Conditions / Equipment Around the CO Incubator79
- Working and Behavior in the Lab80
- Chamber Design and Equipment80
- Handling the CO Incubator81
22 Cleaning, Decontamination / Disinfection, and Sterilization82
- Cleaning83
- Decontamination / Chemical Disinfection of the Chamber84
- Disinfection of the CO85
  - Sensor85
23 Hot-Air Sterilization at 180 °C / 356 °F86
- Overview86
- Performing a Hot-Air Sterilization87
  - Preparations for Hot-Air Sterilization87
- Starting and Running the Hot-Air Sterilization Cycle88
- Prematurely Terminating the Sterilization Cycle - Effects90
  - Premature Termination after Less than 6 Hours: Ineffective Sterilization90
  - Premature Termination after more than 6 Hours, I.e., During the Cooling-Down Phase: Successful Sterilization91
- Prematurely Terminating the Sterilization Cycle - Procedure91
24 Maintenance, and Service, Troubleshooting, Repair, Testing93
- General Information, Personnel Qualification93
- Maintenance Intervals, Service94
- Service Reminder94
- Gas Inlet Fine Filter95
- Simple Troubleshooting95
- Sending the Chamber Back to BINDER Gmbh99
25 Disposal100
- Disposal of the Transport Packing100
  - Outer Chamber Packing100
  - Packing Inside the Chamber, Equipment100
- Decommissioning101
- Disposal of the Chamber in the Federal Republic of Germany101
- Disposal of the Chamber in the Member States of the EU Except for the Federal Republic of Germany102
- Disposal of the Chamber in Non-Member States of the EU103
26 Technical Description104
- Factory Calibration and Adjustment104
- Over Current Protection104
- Definition of Usable Volume104
- CB-S / CB-S-UL Technical Data105
- Important Conversion Data for Non-SI Units106
- Conversion Table for Gas Inlet Pressures, Bar - Psi107
- Equipment and Options (Extract)107
- Options, Accessories, and Spare Parts (Extract)108
- Dimensions109
27 Certificates and Declarations of Conformity111
- EU Declaration of Conformity111
28 Product Registration113
29 Contamination Clearance Certificate114
- For Chambers Located Outside the USA and Canada114
- For Chambers in the USA and Canada117

Binder CB-S 170 - 27. Certificates and Declarations of Conformity; 27.1 EU Declaration of Conformity

Table of Contents

Related product manuals