Ignition - Start of fire:
Igniter activation and pellet ignition
Combustion:
Combustion of pellets at the power set in the settings
“Boiler Operating Limit” 1-5
Modulation - Temperature reached:
When the water temperature in the boiler
approaches (-5°C) of the desired boiler water
temperature, boiler goes into "Modulation"
(reduces power)
If the temperature rises further (Desired T.
+5°C) the boiler shuts down and waits for
the temp. in the boiler to fall 5°C below the desired temp.
Cleaning:
The boiler periodically cleans itself during operation.
It blows out the grate in the rebox and cleans the turbochargers.
(The "noise" that occurs is a normal phenomenon)
Cleaning takes a good minute
after which the boiler continues to re-ignite
Shutdown:
When the boiler is switched off (or is switched off by the time pro-
gram),
the boiler starts the shutdown process, increases the fan speed,
to burn the remaining pellets in the rebox, blow out the grate, etc.
The boiler needs to complete the switch-off process and must not be
switched off "by force", by interrupting the electricity.
Combustion
Start of the fire
Cleaning
Ignition
Temp. achievedModulation
Final blowing
www.biodom27.si
BIODOM 27A 31
To Next Page
Loading...