FC1400 User Manual
FC1400OM-2.04 14 / 95
This equipment must only be connected to a supply mains with protective ground.
Avoid contact with the connector pin of the equipment and the patient at the same time while
the equipment is in use.
Do not connect or remove the power cable with wet hands.
In case the medical equipment does not operate normally, or if it has been damaged, do not use
it on any patient; instead, contact the medical equipment engineer in your hospital or the
equipment supplier.
Devices for fetal heartbeat sound measurements using ultrasonic (US) waves or
uterine contraction measurements (TOCO) performed from outside of the uterus are
not designed for use during any electric operation, defibrillation, or defibrillator
discharge.
The equipment has not been designed for use with other types of monitoring
equipment apart from those devices permitted for use together with the equipment in
this manual.
Do not touch signal input, signal output or other connectors, and the patient
simultaneously.
ELECTROSURGERY - The monitor is not designed for use with high- frequency
surgical devices. In addition, measurements may be affected in the presence of strong
electromagnetic sources such as electrosurgery equipment.
Biocompatibility
When used as intended, the parts of the product described in this operator manual, including
accessories that come in contact with the patient during the intended use, fulfill the biocompatibility
requirements of the applicable standards. If you have questions about this matter, please contact
BIONET or its representatives.
To Next Page
Loading...
