Bionet FC1400 - Chapter 13: Network; Central Connection and Bed Number

FC1400 User Manual
FC1400OM-2.04 66 / 95
FC1400 Operation Manual
 Central setting
If you set the state “ON” by touching “Central” button, the device can be connected to the
Central. If you set the state “Off”, the connection will be terminated.
Warning
First, check the Wireless LAN module equipment to make sure that it is properly
seated, before Central of state and Wireless change “On”
Wireless is not set to "On" in unrecognized status.
 Changing the bed number
To change the Bed number, which is designed to identify the equipment, touch “Bed Num” in the
setting menu.
The Bed number can be selected from 1~16
NOTE
Wireless AP's ID are recognized only if using alphanumeric characters.