Biosite Triage Meter Pro - Installation Procedures; Initial Meter Setup

N-1Rev A
The Main Menu
1. Unpack Meter:
a. Remove the meter from the box and protective plastic bag.
2. Power Meter On:
Batteries
a
. Turn the meter over.
b. Remove battery cover.
c. Install 4 AA batteries, paying attention to battery orientation in the battery
compartment.
d. Replace battery cover and turn meter right side up.
e. Power the meter on by pressing the key. Press the key to run self-test.
When the test is completed, the meter display screen will come to rest at the
main menu.
AC Power Supply
a. Remove the power supply from the box.
b. Plug one end into an AC outlet.
c. Plug the opposite end into the round hole in the back of the meter.
Installation
Note: The Low
Power Indicator
monitors the active
power source. To
verify adequate
batter
y power:
•
Navigate to the
Main Menu
• Remove the AC
power supply
• Press the EXIT key
(the meter attempts
to eject a device)
• Observe the Main
Menu on the
meter
’s display.
Replace the batteries
if the power icon is
visible.
User instructions
Low Power Indicator
Menu items
Time and date