Biosite Triage Meter Pro - Set Parameters; List of Programmable Parameters; Supervisor Access

Rev BN-10
Set Parameters
Code Chip module
Code Chip module Port
Purpose
T
he
SE
T
PA
RAMETERS
f
unction allows the supervisor to select a number of settings.
A
ccess to these settings is controlled using the Supervisor Code Chip module.
List of Programmable Parameters
A
supervisor can set the following parameters:
Heading Parameters
ME
TER
SE
TTINGS
ID SE
TTINGS
Number of Characters in User ID, Number of Characters
in Patient ID, Number of Characters in Auxiliary ID,
Enable or Disable Auxiliary ID
DISPLAY SETTINGS Language, Printer Mode, Auto Power-Off, Display Contrast,
Printer Contrast
COMMUNICATIONS Enable or Disable LIS, Baud Rate, Auto or Manual Upload,
Result Approval
CLOCK Time, Date, and Display Format
USER ID Add New User ID, Update User ID, Delete User ID
or User ID List
RANGES Test Cutoffs
TEST SETTINGS Block Analytes, Display Mode
QC PARAMETERS Minimum frequency for QC Tests, number of controls
BYPASS Disable User ID requirement
Supervisor Access
A Supervisor Code Chip module is shipped with each meter
. Installing the Code Chip
module gives the supervisor access to the
SET PARAMETERS and DELETE RESULTS
function.
T
o insert the Supervisor Code Chip module into the Triage MeterPro, slide the chip labeled
"SPR" into the meter
’s Code Chip module port as shown in the picture.