N-28 Rev A
NU
MBER OF
CO
NTROLS
1
. From the list of programmable parameters, choose
Q
C P
A
RAMETERS
u
sing the keys.
2. Press the key.
3. Use
keys to select the information to the right of NU
MBER OF
CO
NTROLS
.
4. Using keys, select one of these options: 1 or 2.
5. Press the key to save changes.
BY
PASS
US
ER
ID
This function allows the supervisor to selectively bypass the requirement to enter
a user ID before performing any test.
1. From the list of programmable parameters, choose BY
PASS
using the keys.
2. Press the key.
3. Select USER ID using the keys.
4. Use keys to select from two options: ON or OFF.
5. Press the key.
Note: If the
bypass
is
ON, the User ID
requirement is
disabled and therefore
not required.
When the bypass is
OFF, the User ID
requirement operates
as normal and is
required.
MAIN MENU
SET PARAMETERS
Q
C
PARAMETERS
To Next Page
Loading...
