BP-007 User’s Manual
- 30 -
■ Mode of Alignment Adjusting
While pressing the FEED key and holding on, turn on the printer. The printer sounds three beeps,
and you should loosen the FEED key at the same time. The printer will print the degree of
alignment adjusting.
Each press the FEED key will add 1 to the original value. If you select BID 08, press FEED key for
8 times, and then press this key for a long time, it will be saved after sounding two beeps, and the
present selected value will be printed at the same time. Turn off the printer; the new value will be
active after the printer is restarted.
NOTE: Adjustment of alignment will affect printing quality. You must think carefully before
adjusting and must operate strictly according to instruction.
■ Hex Dump Mode
While pressing the FEED key and holding on, turn on the printer. The printer sounds four beeps,
and you should loosen the FEED key at the same time. The printer will enter the Hexadecimal
Printing Mode.
To Next Page
Loading...
