BitaTek Cyclops Series - Data Transfer Via Bluetooth under Batch Mode; SPP Communication

CYCLOPS-I BT Scanner Configuration Guide 12
5.2. Data Transfer via Bluetooth Under Batch Mode
Scanned data saved in data file memory under Batch Mode can be retrieved via Bluetooth.
CYCLOPS-I has to be changed to Bluetooth Data Transfer Mode. Please refer to < 5.3 SPP
Communication >.
Item
Description
Data File
Transferred via
Bluetooth
Two different ways to retrieve Data File via Bluetooth:
 Press（SCAN Key + FUNCTION Key）
 Scan the “BT Data Transmission Mode Change” configuration
barcode (A033)
5.3. SPP Communication
CYCLOPS-I will execute handshaking process with host device ( ex. PC, iPhone, iPad, or
Android smart devices ) based on the setting of CYCLOPS-I configuration under SPP
communication mode. So, a special application program has to be installed on the host device
to handle the communication handshaking process with CYCLOPS-I.
Table below is for application setting reference.
Master Mode
CYCLOPS-I sends pairing request to host device.
Please refer to <The setting barcode about physical address of Bluetooth
module>.
Bluetooth physical address of host device can only be 12-digital.
Slave Mode
Host device sends pairing request to CYCLOPS-I.
Please refer to <The Setting barcode about Device Name of
CYCLOPS-I>
BT manger application of host device selects device name for CYCLOPS-I.
※ If CYCLOPS-I wants to be connected with BT dongle of PC or laptop, version of the
dongle must be 2.0 or beyond.