BitaTek Cyclops Series - 3 Function Key Description

CYCLOPS-I BT Scanner Configuration Guide 7
3. Function Key Descriptions
The follow table gives the description of actions of the FUNCTION key in various Operating
Modes.
Actions
Power
Batch
Mode
Real-Time Mode
Hybrid Mode
HID
SPP
Disconnect
SPP
Disconnect
SCAN Key
( press more
then 3
seconds)
Power
ON
1
—
—
—
SCAN Key
+
FUNCTION
Key
—
Data file
transfer via
Bluetooth
(WAIT
state
2
)
—
—
SCAN Key
—
Barcode Scanning
FUNCTION
Key
—
DELETE
one recode
in data file
3
SEND
key
code
4
SEND
key
code
5
RECONNECT
SEND
Key
code
RECONNECT
RESET
Button
—
RESET
6
1
CYCLOPS-I will auto Power off.
Press SCAN key and hold more then 3 seconds, CYCLOPS-I will be ON and load the
system configuration parameters.
2
When in Bluetooth Data Transfer Mode, CYCLOPS-I will wait for host command from
host devices like: smart phone, tablet device, or PC .
3
The “ DELETE “ function can be ENABLED or DISABLED based on your settings.
Scanned data will be saved in the data file of Flash-ROM. You can delete the records in the
data file. Datas records will be deleted one at a time so no multiple records will be delected
at the same “ DELETE “ action. DELETE will be executed in “ Last In, First Out “ (LIFO)
manner.
4
The software keyboard of iPhone or iPad can be called by pressing FUNCTION key Via
Bluetooth, Different Key Codes can be ENABLED or DISABLED for data transmission.
5
Different Key Codes can be ENABLED or DISABLED for data transmission.
6
CYCLOPS-I will be powered OFF after RESET.