BitaTek Cyclops Series - 9 System Detail Configurations; Factory Default Settings

CYCLOPS-I BT Scanner Configuration Guide 27
9. System Detail Configurations
9.1. Factory Default Settings
CYCLOPS-I Factory Default Parameters are shown as in the following table.
Item
Default
CYCLOPS-I Operating Mode
Real-Time Mode
Communication Mode
HID Mode
Device Name
BTS600 + last 4-digital of BT MAC Address
Authentication
Disable
Encryption
Disable
PIN Code
“0000”
Auto Power-OFF Time-Out
3-minute
Beep on Reconnect/Disconnect
Enable
Beep on Failed Scan
Enable
Buzzer Sound Volume
High
Default Parameters of Real-Time Mode under HID Mode are shown as in the table below..
Item
Default
Record Termination Character
Carriage Return(Enter)
Function Key Code
Eject Key※
Delay Time Before Data Transmission
None
Delay Time Between Characters
None
※ Press FUNCTION Key will call soft keyboard of iPad or iPhone display / hide, The
FUNCTION key can be enable/disable by setting.