CYCLOPS-I BT Scanner Configuration Guide 21
8. Configuring CYCLOPS-Scanner
To choose the most suitable Mode to use CYCLOPS-I in your application, please refer to <7.
Using CYCLOPS-I Scanner>.
8.1. Batch Mode Setting
If the application needs to scan barcode data and store the scanned data into the memory of
CYCLOPS-I, Batch Mode will be the mode suitable for this application.
Scanned data stored in the CYCLOPS-I memory can be retrieved in two different ways:
1. via USB connection: please refer to <6. USB Connection>
2. via Bluetooth connection: It will need an application be installed and running on the host
device like Android smart phone、PC. please refer to <5. Bluetooth Connection>.
8.1.1. Data Transfer via USB Connection
※ CYCLOPS-I must be set in SPP Slaver Mode even if the data will be transferred via USB
cable.
To Next Page
Loading...