BitaTek Cyclops Series - 6 USB Connection; Specifications

CYCLOPS-I BT Scanner Configuration Guide 17
6. USB Connection
6.1. Specifications
CYCLOPS-I has an USB port. It supports charging function when been connected through
USB cable with host device USB port.
Item
Descriptions
Communication
Specification
USB 2.0 Full speed
USB Mass Storage Device
Connector
Micro-USB, type B
Charging
DC5V
Please charge CYCLOPS-I with AC adapter provided by Bitatek or
authorized distributors/resellers. CYCLOPS-I can also be charged using
the optional USB interface cable via host system USB port directly.
Charging CYCLOPS-I using unauthorized AC adapter might lead to
damaging CYCLOPS-I due to improper voltage or current ratings. Failed
to fully charge CYCLOPS-I is also possible if improper charging tool
been used.
Notes:
 USB cable: please use standard CYCLOPS-I USB cable provided
by BITATEK or authorized distributor/reseller.
 USB HUB might not be able to charge CYCLOPS-I due to not been
designed as standard USB power source.
 Please pay special attention on abnormal charging time ( extended
lengthy charging time or extremely short charging time ) while
charging CYCLOPS-I via AC adapter or host device USB port.
 Bluetooth communication and barcode scanning functions are
normal and operational on CYCLOPS-I while been charged by AC
adapter.
 Bluetooth communication and barcode scanning functions will be
disabled on CYCLOPS-I while been charged via USB port.