BitaTek Cyclops Series - Page 28

CYCLOPS-I BT Scanner Configuration Guide 28
Under SPP Mode, the Real-Time Mode, Batch Mode (Bluetooth data transfer mode), and
Hybrid Mode settings are shown as in the following table.
Item
Default
Master Mode Reconnection Interval
30 seconds
SPP Data Transfer Format
STX[Digit][Data][CheckSum]ETX
ACK/NAK Handling of SPP Mode
Enable ACK/NAK handling
※
※ Under Real-Time Mode and Batch Mode, the “ACK/NAK Handling of SPP Mode ” can be
set enable / disable, In Hybrid Mode, this has to be “enable”, can not be changed to
“disable”.
Default Parameters of Batch Mode are shown as in the following table.
These settings will not affect Real-Time Mode initialization.
Item
Default
Time Stamp Format
YYYY/MM/DD,hh:mm:ss
Record Termination Character
CRLF
Termination Character
，
Data Transfer Sequence
Unsent Data Only
Memory Initialization Setting After Data
Transmission
Disable (data file will not be deleted)
Default Parameters of CYCLOPS-I scanner are listed as in the following table.
Item
Default
Trigger Mode
Level
Codabar, MSI, Discrete 2of5,
Interleave 2of5
Level 4
Inverse Barcode
Regular
Code ID character
Disable
UPC-A
Enable
UPE-E
Enable
UPE-E1
Enable
EAN-8
Enable
EAN-13
Enable
Bookland EAN
Disable
Bookland ISBN Format
ISBN-10
UPC/EAN supplemental (Add On)
None