BK Precision 880 - Supplemental Information; Selecting Test Frequency

53
Summary of Supported SCPI Commands
Command
Parameter
Function
FREQuency
<Value>
Set the Test Frequency
FREQuency?
Query the Test Frequency
VOLTage
<Value>
Set the Test level
VOLTage?
Query the Test level
FUNCtion
:impa
<Literal>
Select the primary display parameter
:impa?
Query the primary display parameter
:impb
<Literal>
Select the secondary display parameter
:impb?
Query the secondary display parameter
:EQUivalent
<Literal>
Set the equivalent mode
:EQUivalent?
Query the equivalent mode
CALCulate
:TOLerance
:STATe
<Boolean>
Enable/disable the tolerance mode
:STATe?
Query the tolerance mode
:NOMinal?
Query the nominal value
:VALUe?
Query the percent of tolerance
:RANG
<Value>
Set the limit bin
:RANGe?
Query the limit bin
:RECording
:STATe
<Boolean>
Enable/disable the recording function
:STATe?
Query the recording state
:MAXimum?
Query the max. value of recording
:MINimum?
Query the min. value of recording
:AVERage?
Query the average value of recording
:PRESent?
Query the test value of recording
FETCh?
Query the measurement result
Table 7 - Summary of SCPI Commands