BK Precision 880 User Manual

57
SPECIFICATIONS
Below are some remarks in regards to all specifications pertaining to the 880 LCR meter.
*Specifications are subject to change without notice.
Notes:
1. Measurement performed at the test socket.
2. Measurements performed after correct open and short calibration.
3. DUT and test leads must be properly shielded to guard if necessary.
4. Based after 30 minutes of warm up time and operated at 23 °C + 5 °C, <75% R.H.
5. Q value is the reciprocal of DF.
6. Accuracies based within 10% to 100% of full scale of range; values outside of range
should be used as reference only.
7. Based on battery powered operation.
8. --- means parallel or series measurement mode.
General Specifications
Items
880
Measurement Parameters
L/C/R/Z/DCR/D/Q/θ/ESR
Test Frequency
Accuracy is 0.02% of
actual frequency
100 Hz, 120 Hz, 1 kHz, 10 kHz, 100 kHz(test setting)
100Hz, 120.048Hz, 1 kHz, 10 kHz (actual frequency)
Tolerance Mode
1%, 5%, 10%, 20%
Backlit Display
Yes
Test Signal Level (typical)
0.3 Vrms, 0.6 Vrms, 1 Vrms.
DCR signal：1Vdc
Measuring
Circuit Mode
Series mode / Parallel mode
Basic accuracy
0.1% (See accuracy specifications for details).
Ranging Mode
Auto
Measuring Terminals
3-terminal, 5-terminal with sockets
Measurement Rate
LCRZ
4 meas/sec,1.5meas/sec
DCR
3 meas/sec,2.5meas/sec
Response Time (typical)
680 ms
Auto Power-Off
5, 15, 30, 60 mins, None
Auto LCR Function
Manual, Auto
Output Impedance
100Ω
Count
Max. Counts of Primary Parameter: 40,000; D / Q / θ minimum
resolution of secondary parameter: 0.0001.
Low Battery Indication
Approximately 6.8 Volts
Battery Life
16 Hours (typical) based on backlight off and new alkaline
6 Hours (typical) based on backlight off and new fully charged Ni-
MH battery

BK Precision 880 Specifications

General

Brand	BK Precision
Model	880
Category	Measuring Instruments
Language	English