16
Step 1: Remove the two screws of the AC input terminal cover.
Step 2: Slide the unterminated AC power cord through the hole of the AC input terminal cover.
Step 3: Place the three wire ends of the power cord to the correct terminals. Refer to below for
reference. Securely tighten each wire to the terminals with the screwdriver.
Step 4: Place the AC input terminal cover over the input terminal and secure the two screws.
Gently pull the cover and the power cord afterwards to ensure that both are secured to the
instrument.
2.3 Output Connections
The main front panel is equipped with one universal AC outlet for the 9801 and two universal
AC outlets for the 9803 and 9805. These outlets accept all standard types of common AC power
plugs. This AC output is isolated from the AC power input of the instrument.
Figure 18 – Universal AC Output Socket
Figure 17 - Single Phase Mains Connection
To Next Page
Loading...
Need help?
General