40
1.8 7 7. 87 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7.877. 2269
CHAPTER 8: OSD FUNCTIONS
If the IP address of the Receiver and Transmitter are not on the same subnet, a router is required to allow them to communicate. This
is true even when the Receiver “discovers” the Transmitter’s IP address. One way to avoid this is to change the Receiver address to
be on the same subnet as the Transmitter, make the required configuration changes to the Transmitter, and then change the Receiver
back to its required IP address.
Transmitter Information
The Information button provides Transmitter related information such as Device Model, Serial Number, MAC address, and current
Firmware Version to the administrator.
If the active IP address is not the address of a valid Emerald SE Transmitter or this address is unreachable, an error message is
returned.
Transmitter Upgrade
The administrator can click the Upgrade button to change the firmware on a Transmitter. The upgrade file is selected from the set of
files on an attached USB drive. These files will have the extension .clu . The selected file is checked to be a valid Transmitter upgrade
file before starting the upgrade. The OSD provides a series of screens to walk the user through the process.
The upgrade can take a few minutes to complete and the power to the Transmitter and the Receiver must not be disconnected during
the upgrade. During the upgrade process, the Transmitter may reboot.
If the active IP address is not the address of a valid Emerald SE Transmitter or this address is unreachable, an error message is
returned.
Transmitter Restore Factory Defaults
The administrator can click the Restore button to reset the Transmitter back to factory defaults. If the active IP address is not the
address of a valid Emerald SE Transmitter or this address is unreachable, an error message is returned.
Transmitter Reboot
The administrator can click the Reboot button to power-cycle the Transmitter. If the active IP address is not the address of a valid
Emerald SE Transmitter or this address is unreachable, an error message is returned.
Transmitter Preferences
The administrator can click the Transmitter Preferences to change Video Quality Setting or HID Configuration. When the Transmitter
Preferences button is clicked the window shown in Figure 8-21 pops up.
To Next Page
Loading...
