Blaupunkt BLUEBOT XSMART - Different Cleaning Kits for Different Cleaning Purposes; Cleaning Modes

47
EN
3.2 Dierent cleaning kits for dierent cleaning purposes
The robot comes with cleaning kits for dierent cleaning purposes.
See Table 4:
Cleaning purpose Floor type (examples) Cleaning kits
dry cleaning carpets (< 2cm) normal suction nozzle
dry cleaning laminate ooring brush suction nozzle
wet cleaning laminate ooring and tiles oors mopping kit
Table 4 - Selecting the suitable cleaning kit
See section 5.3 for instructions about installation of the correct cleaning kit.
3.3 Cleaning modes
The robot has ve Cleaning modes.
•
Auto Cleaning mode:
The robot will rst start mapping the area by cleaning the edges of the
area. When mapping is complete, the robot will start cleaning the area
by zigzag movements. When nished, the robot will return to the
charging station.
•
Edge Cleaning mode:
The robot will only clean the edges of the area. When nished, the robot
will return to the charging station.
•
Area Cleaning mode:
The robot will clean an area of 2 m² using maximum suction. Place the
robot on the desired area. When nished, the robot will stop automatically.
•
Random Cleaning mode:
The robot will clean the area by random movements. The robot is not
able to map the area. When the battery is almost empty, the robot will
return to the charging station.
•
Intensive Cleaning mode:
The robot will rst start mapping the area by cleaning the edges. When
mapping is complete, the robot will start cleaning the area by zigzag
movements. The robot will then clean the area a second time. When
nished, the robot will return to the charging station.
Sections 6.2 and 6.3 describe how to select and run the various Cleaning
modes.