Blaupunkt BLUEBOT XSMART - Cleaning the Charge Poles; Cleaning the Suction Passage and the Dust Sensor

72
8.5 Cleaning the charge poles
To clean the charge poles, do the following:
1. Make sure the power switch is o and the robot is not in Stand-by or in
Sleep mode.
2. Clean the charging poles, with a soft cleaning cloth or tool.
1
CAUTION!
Do not clean the charging poles with water. This could damage the robot.
8.6 Cleaning the suction passage and the dust sensor
To clean the suction passage and the dust sensor, do the following:
1. Make sure the power switch is o and the robot is not in Stand-by or in
Sleep mode.
2. Clean the suction passage and the dust sensor with a soft cleaning
cloth or tool.
1
CAUTION!
Avoid the sensors getting wet. This could damage the robot permanently.