Blaupunkt BLUEBOT XSMART - Cleaning the Sensors and Wheels

71
EN
7. Wash the dust bin with water and clean the HEPA lter
with a brush. Let the primary lter air dry.
1
CAUTION
Do not dry the primary lter and HEPA lter in direct sunlight.
8. Insert the primary lter and HEPA lter in the dust bin.
Make sure the primary lter is fully dry.
8.4 Cleaning the sensors and wheels
To clean the sensors and wheels, do the following:
1. Make sure the power switch is o and the robot is not in Stand-by or in
Sleep mode.
2. Slightly wipe all the sensors and wheels with a soft cleaning cloth or
tool.
1
CAUTION
Do not clean the sensors and wheels with water. This could damage the
robot.