58
5.6 Charging the robot
NOTICE
Before the rst use, ensure that the robot is charged for 12 hours.
There are two ways to charge the robot:
•
In the charging station, see Figure 15. The power light on the charging
station will light up when charging is underway.
•
With the power adapter directly connected to the robot. To do this,
insert the adapter into the robot and plug the other end into a power
socket, see Figure 16.
Figure 15 - Charging the robot with the charging station
Figure 16 - Charging the robot directly with the power adapter
NOTICE
•
When the robot is charging, the LED panel will show ‘1111’ rolling across
the panel. It takes approx. 12 hours to fully charge the battery. The LED
panel will show FULL when it is fully charged.
•
When the battery is low and the robot is in standby mode, the robot will
emit the acoustic message ‘Please charge’ and on the LED panel an
empty battery icon will show.
To Next Page
Loading...
