JUST POWER ON62
training, have clear knowledge about the Energy Storage System safety instruc-
tion and master the correct operation.
Professional personnel: Personnel who have received correspond technical
training can clearly realize what risk may be brought to them during the opera-
tion, and able to take measure promptly to minimize the personal risk.
Energy Storage System or components (include software) must be replaced by
professionals or authorized personnel.
1.2.2 Requirement of anti-static
When installing the cables, it is recommended to wear anti-static glove or
anti-static bracelet before contacting the Energy Storage System. The other side
of anti-static Bracelet should be grounded properly. Don't touch any exposed
components directly with your hand.
1.2.3 Precaution of drilling
When drill on the wall or ground , the following safety protection measures should
be considered;
Forbid to drill on the Energy Storage System. Drilling will damage the Energy
Storage System’s appearance, internal components and cable insulation. In
addition, if metal debris enters the internal of Energy Storage System , it will cause
internal circuit board short circuit;
Wear goggles and protective gloves when drilling;
In the process of drilling , the power station should be covered and protected
in case of the debris or dust drop into the power station. The debris and dust
should be cleaned out promptly after drilling.
1.3 Precaution of electrical connection
The EP600 energy storage system will generate high voltage during operating,
which may cause casualties, personal injury or serious damage to property. Please
comply with relevant safety regulations during the installation、trial run、
operation and maintenance of the product.
To Next Page
Loading...
