JUST POWER ON10
1.5 Battery Safety
1.5.1 Statement
BLUETTI shall not be liable for equipment abnormality component damage,
personal injury property loss or other damage caused by the following reasons:
• Failure to promptly charge the battery after installation and system connection, leading
to over-discharge and subsequent damage.
• Inadequate maintenance as instructed in the user manual, includes irregular charging,
improper capacity expansion, or prolonged periods of incomplete charging and frequent
over-discharging of the battery. If you need expansion, please contact BLUETTI support
within 6 months of installation. Do not attempt this on your own.
• Failure to charge the battery as required during storage, resulting in capacity loss or
irreparable damage.
• Improper operation or connection errors causing battery short-circuits, damage, drops, or
leaks.
• Battery damage caused by operating conditions or external power parameters that do
not meet environmental requirements.
1.4.2 Anti-static Requirements
•
Wear or use personal protective equipment (PPE) or clothing that is appropriate for
the work; this may include items such as safety glasses or goggles, or a face shield
(with safety glasses or goggles), hearing protection, dust mask, gloves, anti-static
bracelet, safety boots or shoes, or rubber boots.
• If you use an anti-static bracelet for electrical connections, make sure the bracelet
is properly grounded.
1.4.3 Drilling Requirements
When drilling holes in the wall or on the ground, the following safety measures
should be considered.
• Wear goggles and protective gloves at all times.
• Shield and protect the equipment to prevent debris from falling into it and remove
all debris after drilling.
• Drill holes on the unit are forbidden, as this may damage the equipment's electro-
magnetic shielding performance. The metal shavings may cause short circuits on
the circuit board.
To Next Page
Loading...
