BobsCNC Evolution Series - Getting Started; Required Tools; To Operate the EVOLUTION 5 CNC Router, You Need will Need; Recommended for the Electronic Setup Include

7
Getting Started
Required Tools:
A pair of long nose pliers.
Diagonal Cutters or sharp knife to trim nylon ties.
Calipers or measuring tape to measure part placement.
Small standard screwdriver to connect electronics.
#2 Phillips screwdriver to mount home switches and stepper motors.
#3 Phillips screwdriver to build the main components.
220 grit sandpaper to remove laser marks on wood pieces (if desired).
LOCTITE 242™ thread lock (fingernail polish can be used as a substitute).
Set of Metric Sockets and SAE Wrenches.
Set of Metric and SAE Allen Wrenches.
To Operate the EVOLUTION 5 CNC Router, you need will need:
Computer with control software for GRBL.
Materials for Projects.
1/4” Shaft Router bits.
Recommended for the electronic setup include:
Multimeter to correctly connect the Power Supply and to set the current for
the Stepper Motors (a great tool for general electronic trouble shooting).