8
Assembly Recommendations:
Use a large, flat, clean work surface for assembling your EVOLUTION 5.
All Screws (unless noted) should be installed snug, then rotated 1-2 ½
turns.
Apply LOCTITE to all M4 X 16 mm Machine Screws that are used to secure
plywood pieces except for the 4 screws that clamp the router in step 10 of
the final assembly.
Light sanding may be required to remove any marks made by the laser.
Painting, or applying stain with a clear coat will provide extra protection to
the wood components
Try using strips of 1-inch blue painters’ tape behind the T-Slots to help hold
the Nuts in place during assembly.
Clean the Rails with acetone to remove rust preventative and apply a light
coat of PTFE lubricant.
Lock Nuts are never used to secure components that have T-Slots. They
are only used to mount components where the Nut is not held in a
T-Slot.
To Next Page
Loading...
