The Bluetooth will need to be disabled if you choose to communicate to the printer via the USB port.
This may be done as follows:
1. Depress both the MENU and TEST buttons while turning on the printer. Keep both buttons depressed unit
OPERATOR MENU appears in the LCD window or the display starts scrolling through different topics.
2. Using the MENU button scroll down to the BLUETOOTH?
3. Using the CHOICE button select DISABLED. Once you have done this press the TEST button. The display
will show EXIT AND SAVE, press the TEST button a second time. The printer will reset and will be
disabled.
Bluetooth function is disabled.
Bluetooth function is enabled.
4. To activate the Bluetooth, repeat the above steps but as step #3 select ENABLED.
If the printer doesn’t have an LCD display, then the below command may be sent to the printer instead. This
command only needs to be sent to the printer once to take permanent effect and the printer will reset upon
receipt of said command. The DOWNOADING SOFTWARE COMMANDS section provides download
procedures.
<bld> = DISABLE
<ble> = ENABLED
Click here to return to > Table of Contents
To Next Page
Loading...
