Bolin Technology KBD-1010-R - Joystick Zoom Setting; Joystick Zoom Configuration; Model Info; Viewing Model Information

38
Joystick Zoom Setting
The joystick ring can control the camera’s zoom. This can be toggled under Setup/
Joystick Zoom.
This setting can be changed by rotating the Zoom Speed knob while the setting is
selected
Click the Zoom Speed knob to save this setting if changed
If this setting is set to “OFF”, the Zoom Seesaw will remain active and can be used to
control zoom
Model Info
The Model info screen contains the current IP
address and Firmware Version and IP Firmware
Version of the unit
Visca over IP
This menu is used to configure Visca over IP.
Payload Header:
• A set of data carried with Visca-Over-IP
protocol for camera compatibility identification.
Some Visca-Over-IP cameras don’t have it.
• The camera maker that has the Payload Header:
SONY, BOLIN. For the cameras from these
makers, Set it ON
• For the cameras from other makers, Set it OFF.
Or consult the camera provider.
Port: The control port for Visca over IP.
• By default, is 52381.
• Camera maker SONY, BOLIN use port 52381.
• Other camera makers may use port 1259.
IP CONFIGURATION
BUTTON LIGHT
ASSIGNED KEY: F1
FACTORY DEFAULT
GPI I/O
PASSWORD SETTING
>JOYSTICK ZOOM: ON
MODEL INFO
VISCA IP SETTING
CONTROL MODE
Exit
Keyboard Setting Menu
IP CONFIGURATION
BUTTON LIGHT
ASSIGNED KEY: F1
FACTORY DEFAULT
GPI I/O
PASSWORD SETTING
JOYSTICK ZOOM: ON
>MODEL INFO
VISCA IP SETTING
CONTROL MODE
Exit
Keyboard Setting Menu
>IP Address:
192.>168.> 0.>100
FW Version: X.X.X
IP V X.X.X.
Exit
Model Info Menu
IP CONFIGURATION
BUTTON LIGHT
ASSIGNED KEY: F1
FACTORY DEFAULT
GPI I/O
PASSWORD SETTING
JOYSTICK ZOOM: ON
MODEL INFO
>VISCA IP SETTING
CONTROL MODE
Exit
Keyboard Setting Menu
>Payload Header: ON
Port: 52381
Exit
Model Info Menu