Grasp manual starter handle firmly
and, slowly, crank engine until a resis-
tance appears.
Pass this resistance and release the
handle.
Take again the handle firmly and crank
engine.
Repeat this procedure completely if
necessary.
V01C3RY
1
1. Grasp manual starter handle firmly
and crank engine
Stopping the Engine
WARNING
Avoid parking on an inclined sur-
face.
Release throttle and completely stop
the vehicle.
Apply the parking brake by using brake
lever lock on rear brake lever.
On
Traxter MAX 5 SPEED
, shift to 1st
gear.
Set transmission lever in PARK posi-
tion.
Press the start/stop switch or push the
engine stop switch in OFF position.
Turn key in ignition switch to OFF.
Remove key from ignition switch.
Shifting the Transmission
Let engine idle to warm up.
Apply brakes and select the desired
gear range H/L.
NOTE: The brake must be applied
when the transmission lever is en-
gaged in the park position. Shift to 1
st
gear for the
Traxter MAX 5 SPEED
.
Release brakes.
CAUTION:
Make sure parking
brake is fully disengaged before op-
erating the vehicle.
Traxter MAX CVT
Gradually press the throttle lever to in-
crease engine speed and thus engag-
ing the continuously variable transmis-
sion (CVT).
At the opposite, when the throttle
lever is released, the engine speed
decreases.
Traxter MAX 5 SPEED
Gradually press the throttle lever to in-
crease engine speed and thus engag-
ing the centrifugal clutch.
When vehicle speed increases,
slightly release throttle lever while
pressing the electric gear shift but-
ton to upshift one gear then release
button and press throttle lever again
to continue the acceleration. Repeat
until the last gear if desired or until
vehicle speed you want is attained.
NOTE: While any throttle position
can be used during shifting, it is rec-
ommended to slightly release the
throttle position during upshifting.
Reverse the sequence to downshift.
116
_____________________
To Next Page
Loading...
Need help?
General
