TROUBLESHOOTING
Engine does not turn
1. Ignition switch is in the OFF position.
– Place switch to ON position.
2. Transmission is not set on PARK or NEUTRAL.
– Set transmission either in PARK or in NEUTRAL or press any brake lever.
3. Burnt fuse.
– On
Traxter MAX CVT
, check main fuse condition.
– On
Traxter MAX 5 SPEED
, check MPEM and solenoids fuses condition.
4. Weak battery or loose connections.
– Check charging system fuse.
– Check connections and terminals condition.
– Have the battery checked.
– Contact an authorized Bombardier ATV dealer.
Engine turns over but fails to start
1. Burnt fuse.
– Check ignition fuse condition.
2. Mixture not rich enough to start cold engine
– Check fuel tank level and check starting procedure, particularly use of the
choke.
–
NOTE:
On
Traxter MAX 5 SPEED
, below - 15 °C(5°F) the use of fuel primer
(optional) is required. Also, it is recommended to add gas line antifreeze.
3. Flooded engine (spark plug(s) wet when removed).
– Refer to SPECIAL PROCEDURES.
4. No fuel to the engine (spark plug(s) dry when removed).
– Check fuel tank level; turn fuel valve to ON (also try on RES).
– A failure of the fuel pump or carburetor may have occurred.
– Contact an authorized Bombardier ATV dealer.
5. Spark plug/ignition (no spark).
– Check ignition fuse condition.
– Remove spark plug(s) then reconnect to ignition coil or spark plug caps.
– Check that ignition switch and/or engine stop switch(es) is/are at the ON
position.
– Start engine with spark plug(s) grounded to engine away from spark plug
holes. If no spark appears, replace spark plug(s).
– If trouble persists, contact an authorized Bombardier ATV dealer.
146
_____________________
To Next Page
Loading...
Need help?
General
