BOMBARDIER traxter max series User Manual

N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
H: High gear
This selects the high speed range of
the transmission in the gear box. It is
the normal riding position. It allows
the vehicle to reach its maximum
speed.
L: Low gear
This selects the low speed range of
transmission in the gear box. It is the
working position. It allows the vehi-
cletomoveslowlywiththemaximum
traction and power.
CAUTION:
Use the low speed
range to pull any load or to climb a
steep slope.
6) Multi-Function Switch
Traxter MAX CVT
The multi-function switch is located on
the left side of handlebar.
V04A1PY
1
1. Multifunction switch
The controls located on this multi-
function switch are:
Headlamp Switch
Located on the top of multi-function
switch. Place headlamp switch to LO
for the low beam and taillight. Place
headlamp switch to HI for the high
beam and taillight.
V04A1JY
3
1
2
1. Headlamp switch
2. Low beam position
3. High beam position
NOTE: Place ignition switch to ON
“without light” position to close the
headlamp.
V04A1KY
ON POSITION “WITHOUT LIGHT”
Engine Stop Switch
Located at the middle of multi-function
switch. The engine will turn over but
will not start if the engine stop switch
is turned to OFF position.
_____________________
91

BOMBARDIER traxter max series Specifications

General

Brand	BOMBARDIER
Model	traxter max series
Category	Offroad Vehicle
Language	English